
102
Connecting to the TV (TV1 Outputs)
CONNECTING TO THE TV (TV1 OUTPUTS)
This section describes how to connect receiver TV1 output ports to a nearby TV. Select
one of the following methods.
Note: If you would like to put the receiver in a remote location (closet, cabinet, etc.), be
sure to get the replacement remote control that uses UHF Pro signals to control TV1.
Contact your DISH retailer or go to www.mydish.com
, select Products under Upgrades,
and then click on Remotes & Accessories.
HDMI Connections
The HDMI connection provides high-quality audio and video to your HDTV or HD Monitor
in one cable. If your HDTV or monitor has an HDMI connection available, this is the
recommended connection.
Note: Connecting your TV directly to the audio/video outputs of your receiver will assure a
more vivid picture and enhance your viewing enjoyment.
1 Connect an HDMI cable between the HDMI connection on the receiver and HDTV set or
monitor.
2 Turn on your receiver and TV using the front panel buttons.
3 Confirm that you are getting a picture from the receiver. Consult your HDTV user’s guide if
you need to change your HDTV to display from the correct Digital Audio/Video input.
4 If you do not see a picture, see No Picture on Your TV on page 103.
Note: In most cases, connecting the HDMI cable will provide plug-and-play control of the
monitor’s display resolution and other settings. However, your HDTV may require
selecting a different format to display video properly from the receiver during its setup.
5 Turn up the volume on your HDTV and confirm you hear sound. If you don’t have sound,
your system may require you to connect stereo audio (red and white), RCA-type cables
between the receiver’s analog audio outputs and your system’s audio input connections.
HDMI
2-4
5
Connect receiver
and monitor with
HDMI cable
Turn monitor
and receiver on
and confirm picture
Confirm
sound and
volume
1
Comentarios a estos manuales